Need help?Do you have a question about the BluGuitar AMP 1 and is the answer not in the manual?
General| Power Output | 100 Watts |
|---|---|
| Channels | 4 |
| Effects | Reverb |
| Effects Loop | Yes |
| MIDI Control | Yes |
| Line Output | Yes |
| Headphone Output | Yes |
| Bluetooth | No |
| Dimensions | 245 x 68 x 192 mm |
| Battery Powered | No |
| USB | No |
| Type | Guitar Amplifier |
| Preamp Tubes | 1x 12AX7 |
| Technology | NANOTUBE |
| Controls | Gain, Volume, Bass, Middle, Treble, Master Volume, Channel Select |
| Speaker Output | 8 Ohms |
Details using AMP1 as a standalone amp on the floor with footswitches and a speaker cab.
Explains building a programmable amp and effects setup using AMP1 and other accessories.
Covers overdrive channel selection and the Nanotube technology.
Details Master Volume, Clean Volume, Overdrive Gain, and Overdrive Master controls.
Explains Sound Controls (Bass, Middle, Treble), Reverb, and Boost functions.
Describes the Clean/Overdrive channel switch and Boost/Reverb on/off switches.
Details the guitar input and FX Send/Return ports.
Covers Recording Out, Speaker Outs, and the Footswitch/MIDI/REMOTE port.
Addresses issues like no sound, incorrect switching, muddy FX, and humming noises.
Provides guidance on proper care and maintenance for the device.
Essential safety precautions and warnings before connecting and operating the AMP1.
Details input, output, and FX loop parameters like impedance and levels.
Covers MIDI system, physical dimensions, weight, and power consumption.
To Next Page