Assembly
▀ All national standards must be followed for SERVO-DRIVE uno as-
sembly. This includes, in particular, those related to the mechanical
safety of moving parts and electrical cabling.
▀ The device may only be connected to a power supply that corre-
sponds to the type and frequency listed on the serial tag (see Blum
transformer).
▀ No damaged parts should be used.
▀ Sharp edges may damage the cable.
▀ The total length of the cable should not exceed 2 m.
Danger of electric shock!
➢ Never open a Blum transformer.
WARNING
▀ Never take apart a drive unit.
▀ Make sure that moisture cannot penetrate the Blum transformer
and drive unit.
▀ Before the installation of SERVO-DRIVE uno make sure that there
is enough space (min 44 mm) behind the pull-out back in the cabi-
net. By cutting out the cabinet back panel you may win
additional space in the cabinet.
6
To Next Page
Loading...
