8
Precautions and general recommendations
Always connect the unit to a water main that supplies
drinking water only.
Before each installation, the unit must be sanitized by
an authorized technician.
After installation, ensure that the unit is not resting on
the power cable.
Check that the unit is level and that it is resting on a wall
with sufficient load-bearing capacity, in an environment
that is suitable for its dimensions and its use.
Before any maintenance or cleaning operation is carried out, remove the plug
from the socket or disconnect the power supply.
Ensure that the product is not sited close to sources of heat.
Install the product in a clean, dry, well-ventilated environment. The water cooler is
designed to function in environments with a temperature range of between 5°C
and 32°C - Climate Class N.
The unit is not intended for use by children.
If the power cable is damaged, it must be replaced by the manufacturer, by
its technical support service or by a qualified technician. Do not use extension
cables or multi-plugs.
Ensure that it is possible to disconnect the power supply either by removing the
plug or via a two-pole circuit-breaker placed upstream of the plug.
Check that the voltage shown on the serial number plate corresponds to the
voltage being supplied at the installation site.
The unit must not be cleaned with a water jet. Do not position other electrical
equipment in the immediate vicinity of the water cooler.
Turn off the main water inlet tap if the unit is not to be used for a long period.
Keep the areas surrounding the unit dry to avoid the risk of people slipping.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance .
The Appliance shall be protected by a ground-fault circuit interrupter.
To Next Page
Loading...