Blusens h305 - Page 89

Blusens H305
43
ENGLISH
Computer no
display, and
prompt no
signal input, red
indicator LED
twinkling
- Signal cable is loose or
fallen off.
- Check signal cable whether
or not loose, fall off, reconnect
again.
Remote control
distance is
short, lose
control
- Receive window of remote
control was covered by
objects.
- The battery energy of
remote control is too low.
- Remove objets obstructing
the receiver window of remote
control.
- Change battery.
Computer
display is faint
- Adjustment is incorrect.
- Display mode is incorrect.
- Use auto-adjustment function.
- Use recommended mode.
Computer
display image
does not fill the
screen
- Adjustment is incorrect.
- Display mode is incorrect.
- Use auto-adjustment function.
- Enter PICTURE to adjust
horizontal or vertical position.
- Use recommended mode.
Noise signals al
turning off
- Electrical release at turning
off.
- It is normal.
Can not operate
this machine
- Exterior influence, for
example lightning, static
electricity and so on, which
are possibly to disturb the
normal operation of this
machine.
- Press button to turn off
electrical source, then press
button to turn on the TV again
after 1-2 minutes.