DA11AU QUICK REFERENCE GUIDE
03contact support@blustream.co.uk / support@blustream.com.au
RevA0_QRG_HD12DB_190606_Web Layout
Advanced Dante Settings
It is also possible to change the settings of the DA11AU under the “Device Info” screen in the Dante Controller
soware. To do so, select the “Device Config” menu.
Here we can adjust the sample rate of the DA11AU. Please note that Dante products can only transmit or receive
audio from other Dante products that are set up with the same sample rate. A mismatch in sample rate may stop
audio from transmitting.
Under the “Device Config” screen we can also adjust the latency of the DA11AU from 1, 2 or 5 milliseconds.
Depending on your audio input device, it may be necessary to adjust the Input Sensitivity of the DA11AU.
Under the “Controls” screen we can adjust the input sensitivity of each channel from the default of +24dBu to
-10dBV.
To Next Page
Loading...
Need help?
General
