BluStream MX44VW - Web Browser and PC Configuration; Blustream Web Browser Interface; Blustream PC Configuration Software; Upgrading Product Firmware

21
contact support@blustream.co.uk / support@blustream.com.au
MX44VW USER MANUAL
Blustream PC Configuration Soware
The Blustream MX44VW matrix unit can be configured using the Blustream matrix PC configuration soware.
Please download the specific soware and PC soware manual at the following link:
http://www.blustream.co.uk/MX44VW
Blustream Web Browser Interface
The Blustream MX44VW matrix unit can be both controlled and configured using the in-built web-server.
The MX44VW Matrix must be connected to an active network router/switch and it is advised that the Matrix is given
a static IP address. You can configure the network settings of the Matrix using either the Web Browser Interface
(Blustream Matrix products are shipped with the network set to DHCP) or using the Blustream PC Configuration
Soware (downloadable from the Blustream Drivers & Protocols link on the product web page).
For detailed instructions on using the Blustream Web Browser Interface please download the specific soware
manual at the following link:
http://www.blustream.co.uk/MX44VW
Upgrading Product Firmware
There may be instances when the Blustream products require a firmware update. All new firmware is available to
download on the Blustream website at the following link:
http://www.blustream.co.uk/MX44VW
To update the firmware you will require the Blustream Matrix PC configuration soware and an RS-232 adaptor cable
to communicate with the product.
Full instructions can be found at the above website address.