P/N 033000=13891 14 Rev.15-05-06
4.6 Identifying codes found
If the batteries are taken out of the remote for a longer
period, the programmed codes can be erased from the
memory. Therefore it is wise to write down the codes, so you
will be able to reprogram the remote control quickly If you
don’t know the code (for example because you found the
code by autosearch) you can identify it as described below:
1. Press and hold SETUP (8) until the LED indicator (2)
lights steadily. Release SETUP.
2. Press the mode key (3) for the equipment you want to
identify (VCR, CBL, DVD, CD, ASAT, DSAT or AUX). The
LED blinks once.
3. Press again SETUP. The LED blinks once.
4. To identify the first digit press each number button from 0
- 9 (9) until the LED blinks. The number you pressed is the
first digit of the code.
5. Press each number key from 0 - 9 as above to find the
second digit.
6. Press each number key from 0 - 9 as above to find the
third digit. When the third digit has been found the LED will
go off.
4.7 Default Volume Control for satellite
In factory default, in Satellite mode the volume is controlled
by the TV. However, some Satellite tuners have their own
volume control. You can reprogram the remote so the
volume is controlled by the satellite receiver instead of by
the TV.
1. Press and release the TV Mode button (3) – remote must
be in TV mode for this procedure.
2. Press and hold SETUP (8) button until LED remains on.
3. Release SETUP button.
4. Press and hold the Mute (4) key for approximately 8
seconds. LED will stay off for the 8 second period, then blink
once to indicate volume default acceptance and then remain
off.
5. Remote volume default is now set.
6. If the Take Control Remote was previously controlling the
television volume in SAT mode, it will now control the
volume of the satellite decoder. If it was previously
controlling the volume of the satellite decoder, it will now
control the volume of the television.
4.8 Home Theatre Macro Feature
Your Take Control remote has three Macro buttons: M1, M2
and M3. You can program these buttons to execute a series
of commands with one press of a button. This powerful
feature is ideal for switching on all your audio and video
equipment at once or for selecting certain preferences in
Home Theatre applications.
Programming the Macro buttons M1, M2 and M3
1. Keep the SETUP (8) button pressed until one of the Mode
LED’s stays lit. Release the SETUP (8) button.
2. Press MACRO (25). The LED will flash once.
To Next Page
Loading...
Need help?
General