BMPRO JAYCOMMAND Help Guide

1
PAIRING TO THE JAYCOMMAND NODE
Pairing your JAYCOMMAND CONTROLLER, smartphone or tablet to the JAYCOMMAND NODE, is done in three
easy steps and the JAYCOMMAND APP will guide you through the pairing process.
NOTE: The JAYCOMMAND CONTROLLER will have been paired to your JAYCOMMAND NODE at the factory.
You should only need to pair your own device or smartphone to the JAYCOMMAND NODE.
While the JAYCOMMAND NODE can be paired to a total of four devices (including the JAYCOMMAND
CONTROLLER), you can only pair one device at a time to the JAYCOMMAND NODE.
1. Launch the JAYCOMMAND APP on your phone
2. Using the < or > button on the JAYCOMMAND CONTROLLER, navigate to the “PA” menu item
3. When “PA” appears on the display, press the EXT button to start the pairing process to the
JAYCOMMAND NODE, “PA” will blink for a maximum of 30 seconds or until a device is
connected.
Use < or > to navigate to the 'PA' menu item
Figure 3: Press EXT once, to start the pairing process

BMPRO JAYCOMMAND Specifications

General

Brand	BMPRO
Model	JAYCOMMAND
Category	Controller
Language	English