Function Modes
Switch on the device by pressing the key until <on> is displayed. Release the key.
While switching on and pressing the key for a longer time the software version and the
status of the Lock Function for calibration (from software 13.1) are displayed.
When you now press the key once again for a longer time the following functions will ap-
pear one after another:
Sto = Store readings in the Data Memory
StA = Display Statistics
Prn = Print or activate the Serial Interface
IcL = Clear the last reading
cLr = Clear the whole Data Memory
nFE = Base material recognition
NFE = recognizes exclusively non-ferrous metals
un = Change the unit of measurement (µm / mils)
rES = Switch over the resolution from 1.0 µm to 0.1 µm
By pressing the key the mode selected is confirmed.
Operation Of The Function Modes
<Sto> Store readings in the Data Memory
To store readings in the memory for further evaluation press the key until <Sto> is dis-
played.
Now release the key and wait until <on> is flashing. Confirm by pressing the key again.
The data memory is activated and all subsequent measurements will be stored. The sym-
bol <STORE> is displayed to make evident that the memory is switched on.
Capacity of the data memory : 1000 readings
When the memory has reached its capacity limit the symbol <FUL> is displayed.
As soon as the device is switched off the memory mode is deactivated.
<StA> Display Statistics
The readings stored in the data memory are evaluated as follows:
No. - Number of readings stored
MIN - Lowest reading stored
MAX - Highest reading stored
MEAN - Mean value
STD.DEV. - Standard deviation
Press the key until the symbol <StA> appears. Now wait until <StA> is flashing and con-
firm by pressing the key again. The statistics values are displayed one after another.
Operation
EASY- CHECK FN
Manual
Rev:00 4 / 10
To Next Page
Loading...