F700/800 Continued..
• Removing centre trim panel.
• Remove screws (1) with plastic washers (2) .
• Remove screws (3) .
• Disengage centre trim panel (4) .
• Begin by connecting one end of the red jump lead to the positive terminal of the
discharged battery and the other end to the positive terminal of the donor battery.
• Then connect one end of the black jump lead to the negative terminal of the donor
battery and the other end to the negative terminal of the discharged battery. NOTICE
The spring-strut screw can be used as an alternative to the battery's negative
terminal.
• Start the engine of the vehicle with the discharged battery in the usual way; if the
engine does not start, wait a few minutes before repeating the attempt in order to
protect the starter motor and the donor battery.
• Disconnect the jump lead from the negative terminals first, then disconnect the
second lead from the positive terminals.
• Installing centre trim panel and seat.
• No keyless start function available on this model
To Next Page
Loading...
