22n
Indicator and warning lamps
Brake pads ●
Have the brake pads checked.
For additional information:
page 92.
Dynamic Brake Control DBC ●
Malfunction in the DBC system.
The brake system continues to
provide unrestricted conventional per-
formance.
Have the system checked and repaired
at your BMW center as soon as pos-
sible.
For additional information on DBC:
page 90.
Dynamic Brake Control DBC
warning lamp for Canadian
models
Dynamic Stability Control
DSC ●
Indicator lamp flashes:
The system is actively regulating engine
torque and braking force.
If the indicator lamp does not go out
after the engine is started, or if it comes
on during normal driving and stays on:
DSC has been switched off with the
button or has been deactivated
because of a malfunction. In the event
of a malfunction, have the system
checked by your BMW center.
For additional information: page 65.
Service Engine Soon ●
If the indicator lamp comes on
either continuously or intermit-
tently, this indicates a fault in the emis-
sions-related electronic systems.
Although the vehicle remains opera-
tional, you should have the systems
checked by your BMW center at the
earliest possible opportunity.
For additional information: page 126.
Service Engine Soon warning
lamp for Canadian models.
Electronic engine-management
system
Malfunction in the electronic
engine-management system. The elec-
tronics revert to a default mode permit-
ting continued operation, but at lower
than usual engine speeds and with
reduced power. Please have the
system inspected by your BMW center.
Yellow: for your information
Rear fog lamp
Lights up whenever the rear fog
lamp is switched on.
For additional information: page 70.
Online Edition for Part No. 01 41 0 156 878 - © 06/02 BMW AG
To Next Page
