96n
Wind deflector Hardtop
Removal
Pull the four straps to release the
retainers, then reverse the installation
sequence to remove the wind deflector.
Fold the wind deflector and place it in
its protective slipcase prior to storing it
in the luggage compartment.
While driving
You can always drive with the wind
deflector installed. Whenever the con-
vertible top is closed, flip the center
section of the wind deflector down to
get a better view to the rear.
1. With the two stud fasteners closed,
first unfasten the zippers entirely
2. Release the two stud fasteners and
lay down the center section either to
the rear or the front, as shown in the
illustration.
When reattaching, first fasten the two
stud fasteners, then zip the zippers up.
520de136
Removal
Your BMW Z8 roadster is equipped
with a hardtop as standard equipment.
Two individuals are required for its
removal. When removing the top,
always proceed with utmost caution to
avoid damage to the vehicle's paint and
bodywork as well as to the hardtop
itself.
1. Set up the hardtop cart as described
in the accompanying assembly
instructions
2. Lower the side windows
3. Press to release the side trim, refer
to arrow
Every time you press on it, you
either lock or unlock the side trim
panel.<
Online Edition for Part No. 01 41 0 156 878 - © 06/02 BMW AG
To Next Page
