BMW 320e - Page 121

3. Press the switch forwards once again beyond
the resistance point and hold until the glass
sunroof closes with no anti-trap function. En‐
sure that the closing area is clear.
Closing without the anti-trap
mechanism from a raised position
If an external hazard or ice prevents you from
closing the windows normally, proceed as fol‐
lows:
1. Close all doors.
2. Slide the switch forwards beyond the resist‐
ance point and hold it in this position.
Initialising after a power failure
General
If a power failure occurs while the glass sunroof
is opening or closing, it may only have limited
functionality afterwards. In this case, initialising
the system can help.
The system can be initialised under the following
conditions:
▷ The vehicle is parked on level ground.
▷ The vehicle does not move until initialisation
is complete.
▷ In drive-ready state.
▷ The outside temperature is above 5 ℃/41 ℉.
During initialisation, the glass sunroof closes with
no anti-trap mechanism.
Ensure that the closing area is clear.
Initialising the system
Press the switch up and hold until
initialisation is complete:
Initialisation begins within 15 seconds.
▷ If the glass sunroof is closed, it opens, then
closes again.
▷ If the glass sunroof is open, it first closes,
then opens and closes again.
Initialisation is complete once the glass sunroof
and sun guard have opened then closed again.
Seite 121
Opening and closing
CONTROLS
121
Online Edition for Part no. 01405A1EA53 - X/20