EasyManua.ls Logo

BMW 320e - Page 125

BMW 320e
458 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Press the button at the top/bottom:
The curvature is shifted upwards/downwards.
Function restriction
It may not be possible to adjust the lumbar sup‐
port at very high and very low temperatures.
Backrest width
Principle
To adjust the backrest width can improve lateral
support when taking corners.
General
The backrest width is changed by adjusting the
side sections of the backrest.
Adjusting
Press the button at the front:
Backrest width is reduced.
Press the button at the rear:
Backrest width is increased.
Function restriction
It may not be possible to adjust the backrest
width at very high and very low temperatures.
Seat belts
General
For the safety of the vehicle occupants, the vehi‐
cle is equipped with five seat belts. However,
they can only provide effective protection when
worn correctly.
Before each journey, always make sure that all
occupants have fastened their seat belts. The
airbags supplement the seat belts as an addi‐
tional safety device. The airbags are not a substi‐
tute for the seat belts.
The belt anchorage is suitable for adults of any
stature if the seat is adjusted correctly.
The two outer belt buckles on the rear seats are
intended for those sitting on the left and right.
The inner belt buckle on the rear seats is inten‐
ded for the person sitting in the middle.
Safety notes
WARNING
If a seat belt is used by more than one person
at the same time, the protective function of the
seat belt is no longer guaranteed. There is a
risk of injury or even death. Only one person
should use each seat belt at any one time. Do
not allow infants and children to travel on the
lap of another occupant. Instead, secure the in‐
fant or child in a child restraint system intended
for this purpose.
WARNING
The protective function of the seat belts may
be limited or may even fail completely if the
seat belts are worn incorrectly. If a seat belt is
not worn correctly, additional injuries can be
caused, for example in the event of an accident,
braking or evasive action. There is a risk of in‐
jury or even death. Make sure that all vehicle
occupants have fastened their seat belts cor‐
rectly.
WARNING
Seat belts are designed to bear upon the bony
structure of the body and should be worn low
across the front of the pelvis, or the pelvis,
chest and shoulders, as applicable. Wearing the
lap section of the belt across the abdominal
area must be avoided.
Seite 125
Seats, mirrors and steering wheel
CONTROLS
125
Online Edition for Part no. 01405A1EA53 - X/20

Related product manuals