change the backrest width from this point on and
do not call up a memory position.
ISOFIX child safety seat
fasteners
General
Please comply with the operating and safety in‐
structions provided by the child restraint system
manufacturer when selecting, attaching and us‐
ing ISOFIX child restraint systems.
Suitable ISOFIX child restraint
systems
Only certain ISOFIX child restraints may be used
in the seats intended for this purpose. The corre‐
sponding size class and size category are deno‐
ted by a letter or ISO reference on a plate on the
child seat.
For further information:
Suitable seats for child restraint systems, see
page 141.
Fixtures for lower
ISOFIX anchors
Safety note
WARNING
If the ISOFIX child restraint systems are not en‐
gaged correctly, the protective effect of the
ISOFIX child restraint systems will be limited.
There is a risk of injury or even death. Make
sure the lower anchor point has engaged cor‐
rectly and the ISOFIX child restraint system
rests firmly against the backrest.
Position
Symbol Meaning
The corresponding symbol
shows the fixtures for the lower
ISOFIX anchors.
The fixtures for the lower ISOFIX anchors are lo‐
cated behind the marked covers.
Before fitting ISOFIX child
restraints
Pull the seat belt away from the area of the child
seat mountings.
Fitting ISOFIX child restraint
systems
1.
Install the child restraint system, see the
manufacturer's instructions.
2. Make sure that both ISOFIX anchors are en‐
gaged correctly.
i-Size child restraint systems
General
i-Size is a regulation for child restraint systems,
which is used for the approval of child restraint
systems.
Seite 139
Carrying children safely
CONTROLS
139
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
