BMW 320e - Page 310

Switching off
Hold down the button until the control
shuts down.
Temperature
Principle
The automatic air conditioning adjusts to the set
temperature as quickly as possible, using maxi‐
mum cooling or heating power if necessary. The
temperature is then maintained.
Adjusting
Using the button:
Press the upper or lower side of the
button to set the desired temperature.
Via iDrive:
1.
"CAR"
2. "Settings"
3. "Climate comfort"
4. "Heating/ventilation"
5. "Driver" or "Front passenger"
6. "Temperature:"
7. Set the desired temperature.
8. "OK"
Avoid switching between different temperature
settings in rapid succession. The automatic air
conditioning may not have sufficient time to ad‐
just to the set temperature.
Ventilation temperature
General
The temperature of the ventilation in the upper
body area can be adjusted.
The temperature is adjusted on an individual ba‐
sis, for example towards the blue for colder and
towards the red for warmer.
The ventilation air flow in the upper body area
provides noticeable heating or cooling depend‐
ing on the set temperature.
The set interior temperature for driver and front
seat passenger is not changed by this.
Adjusting
1. "CAR"
2. "Settings"
3. "Climate comfort"
4. "Heating/ventilation"
5. "Temperature adjustment"
6. Set the desired temperature.
Cooling function
Principle
Interior air is cooled and dried and then heated
again depending on the temperature setting.
The interior can be cooled when the drive-ready
or standby state is switched on.
Switching on/off
Using the button:
Press the button.
Via iDrive:
1.
"CAR"
2. "Settings"
3. "Climate comfort"
4. "Heating/ventilation"
5. "Climate control (A/C)"
Depending on the weather conditions, the wind‐
screen and the side windows may mist over for a
short time when the drive-ready state has been
switched on.
The cooling function is switched on automati‐
cally in the AUTO programme.
Seite 310
CONTROLS
Air conditioning
310
Online Edition for Part no. 01405A1EA53 - X/20