Label
The tyres are identified by Runflat System Com‐
ponent RSC on the tyre's side wall.
Remedying flat tyres
Safety measures
▷ Park the vehicle on a firm surface and as far
away from moving traffic as possible.
▷ Switch on the hazard warning lights.
▷ Apply the parking brake to prevent the vehi‐
cle rolling away.
▷ Engage the steering wheel lock with the
wheels in the straight-ahead position.
▷ Have all vehicle occupants get out of the ve‐
hicle and guide them out of the danger area,
for example behind the crash barrier.
▷ Set up the warning triangle an appropriate
distance away.
Mobility System
Principle
With the Mobility System, minor tyre damage
can be quickly sealed, to allow you to drive on.
For this purpose, liquid sealant is pumped into
the tyres which encloses the damage from the
inside when it hardens.
General
▷ Please observe the notes on the application
of the Mobility System which are on the com‐
pressor and the sealant container.
▷ Applying the Mobility System can be ineffec‐
tive for tyre damage larger than approximately
4 mm.
▷ Contact a Service Partner of the manufac‐
turer or another qualified Service Partner or a
specialist workshop if you are unable to put
the tyre back in operation.
▷ Foreign bodies that have penetrated the tyre
should remain inside the tyre. Only remove
foreign objects if they are visibly protruding
from the tyre.
▷ Remove the speed limit sticker from the seal‐
ant container and attach to the steering
wheel.
▷ Using sealants can damage the wheel elec‐
tronics. In this case, have the electronics re‐
placed at the next opportunity.
▷ The compressor can be used to check the
tyre inflation pressure.
Overview
Storage
The Mobility System is located in a bag in the left
storage compartment of the boot. To remove it,
loosen the tensioning strap.
Seite 374
MOBILITY
Wheels and tyres
374
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
