Tyre settings
General
If the system does not detect the tyres automati‐
cally, the specifications for the fitted tyres can be
entered in the tyre settings.
The tyre sizes of the fitted tyres can be found in
the tyre inflation pressure information on the ve‐
hicle or directly on the tyres.
The tyre data does not have to be re-entered if
the tyre inflation pressure is corrected.
For summer and winter tyres, the tyre data last
entered for each type is saved. This means that
the settings can be retrieved again after a tyre or
wheel change.
Adjusting the settings
1.
"CAR"
2. "Vehicle status"
3. "Tyre Pressure Monitor"
4. "Tyre settings"
5. "Tyre selection"
6. "Manual"
7. "Tyre type"
▷ "Summer"
▷ "Winter/all-season"
8. Select the type of tyre mounted on the rear
axle.
In the case of tyres with special approval:
"Other tyres".
See the Performing a reset section for how to
proceed.
9. Select the load status of the vehicle once tyre
size has been selected.
10."Save tyre settings"
The measurement of the current tyre inflation
pressure is started. The progress of the meas‐
urement is shown.
Status display
Current status
The status of the system, for example whether
the system is active, can be shown on the Con‐
trol Display.
1. "CAR"
2. "Vehicle status"
3. "Tyre Pressure Monitor"
The current status is displayed.
Current tyre inflation pressure
The current tyre inflation pressure is displayed
for each tyre.
The current tyre inflation pressures can vary de‐
pending on vehicle operation or outside temper‐
ature.
Current tyre temperature
Depending on the model, the current tyre tem‐
peratures are shown.
The current tyre temperatures can change as a
result of vehicle operation or the outside temper‐
ature.
Specified pressure
The specified pressure for the tyres on the front
and rear axle is displayed.
The calculated pressure takes account of the
temperature effects caused by vehicle operation
and the outside temperature. The appropriate
specified pressure is always displayed irrespec‐
tive of the weather conditions, tyre temperatures
and length of journey.
The displayed specified pressure may vary and
differ from the value stated in the tyre inflation
pressure information on the door pillar of the
driver's door. The tyre inflation pressure can thus
be corrected to the value of the displayed speci‐
fied pressures.
The specified pressure is adjusted immediately if
the load status is changed in the tyre settings.
Seite 380
MOBILITY
Wheels and tyres
380
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
