BMW 320e - Page 53

tion and intervene actively if the situation war‐
rants it.
WARNING
An unsecured vehicle can start moving and roll‐
ing away. There is a risk of accident. Before
leaving the vehicle, secure it to prevent it from
rolling away.
Observe the following to ensure that the vehi‐
cle is secured against rolling away:
▷ Apply the parking brake.
▷ Turn the front wheels towards the kerb on
upward or downward gradients.
▷ Additionally secure the vehicle on upward
or downward gradients, for example with a
chock.
WARNING
Unsupervised children or pets in the vehicle
can set the vehicle in motion and endanger
themselves or other road users, for example by
the following actions:
▷ Pressing the start/stop button.
▷ Releasing the parking brake.
▷ Opening and closing doors or windows.
▷ Engaging selector lever position N.
▷ Operating vehicle equipment.
There is a risk of accident or injury. Do not
leave children or pets unsupervised in the vehi‐
cle. When leaving the vehicle, take the vehicle
key with you and lock the vehicle.
Switching on drive-ready state
1.
Close driver's door.
2. Press the brake pedal.
3. Press the start/stop button.
Most of the indicator and warning lamps in
the instrument cluster are illuminated for dif‐
ferent lengths of time, depending on the du‐
ration of the system check.
Depending on the preconditions, electric drive-
ready state or starting the internal combustion
engine is possible.
Electric drive-ready state
General
The vehicle is ready to drive without starting the
internal combustion engine.
Operating requirements
Electric drive-ready state is possible if the pre‐
conditions for electric driving are met.
For further information:
BMW eDRIVE, see page 149.
Display in the instrument cluster
When drive-ready state is
switched on, READY is shown in
the instrument cluster.
Internal combustion engine start
Operating requirements
The internal combustion engine is started when
drive-ready state is switched on under the
following preconditions:
▷ Temperature of the hybrid system is too high
or too low.
▷ Charge level of the high-voltage battery is too
low.
Switching off drive-ready state
After stopping:
1.
Engage the selector lever in position P.
2. Press the start/stop button.
3. Apply the parking brake.
Seite 53
Vehicle operating state
CONTROLS
53
Online Edition for Part no. 01405A1EA53 - X/20