General instructions
The "Maintenance" chapter de-
scribes work involving the check-
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
chapter "Technical Data".
Further information about main-
tenance and repair work can be
obtained on DVD through your
authorized BMW Motorrad re-
tailer.
Special tools and thorough spe-
cialized knowledge are required
to carry out some of the work.
If you are in doubt, consult an
authorized workshop, preferably
your authorized BMW Motorrad
retailer.
Onboard tool kit
Standard tool kit
1 Screwdriver handle
2 Reversible screwdriver in-
sert
with Phillips and straight
blade
Remove light sources in
front and rear turn indi-
cators ( 118).
Replacing bulb in license
plate lamp ( 119).
Removing battery
( 126).
3 Open-ended wrench
Wrench size: 17 mm
Adjust mirror arm
( 53).
4 Torx wrench T40
Headlamp range adjust-
ment ( 58).
5 Reversible screwdriver in-
sert
Phillips PH1 and Torx T25
Remove center fairing
panel ( 121).
Service tool kit
with service toolkit
OA
8
94
z
Maintenance
ProCarManuals.com
To Next Page
Loading...
Need help?
General
