Programming
with anti-theft alarm system
(DWA)
OE
Programming options
The anti-theft alarm system can
be adapted to individual needs in
the following points:
Confirmation alarm tone after
activation/deactivation of the
DWA in addition to the turn
indicators lighting up
Rising and falling or intermittent
alarm tone
Automatic activation of the
alarm function when the igni-
tion is switched off
Factory settings
The anti-theft alarm system is
delivered with the following fac-
tory settings:
Confirmation alarm tone after
activation/deactivation of the
DWA: no
Alarm tone: intermittent
Automatic activation of the
alarm function when the igni-
tion is switched off: no
Programming DWA
Deactivate alarm function.
Switch on ignition.
Press button 1 three times.
Acknowledgment tone sounds
once.
Switch off the ignition within
ten seconds.
Press button 2 three times.
Acknowledgment tone sounds
once.
Switch on the ignition within
ten seconds.
Acknowledgment tone sounds
three times.
The programming function is
active.
The actual programming is car-
ried out in four steps, and Step 2
is not assigned any function. The
number of flashing signals on the
alarm system LED of the motor-
cycle shows the active program-
ming step. Pressing the button
1 is confirmed by an alarm tone,
and pressing the button 2 by an
acknowledgment tone.
Step 1: is a confirmation tone
to sound after the DWA is acti-
vated/deactivated?
Yes:
Press button 1.
No:
Press button 2.
6
62
z
Alarm system
ProCarManuals.com
To Next Page
Loading...
Need help?
General
