The window closes while the switch is being
held.
▷
Pull the switch beyond the resistance
point.
The window closes automatically if the door
is closed. Pulling again stops the motion.
Closing via Comfort Access, refer to page 76.
Jam protection system
General information
If closing force exceeds a specific threshold as a
window closes, closing is interrupted.
The window opens slightly.
Safety information
WARNING
Accessories on the windows such as antennas
can impact jam protection. There is a risk of in‐
jury. Do not install accessories in the area of
movement of the windows.
Closing without the jam protection
system
In case of danger from the outside or if ice might
prevent normal closing, proceed as follows:
1. Pull the switch past the resistance point
and hold it there.
The window closes with limited jam protec‐
tion. If the closing force exceeds a specific
threshold, closing is interrupted.
2.
Pull the switch past the resistance point
again within approx. 4 seconds and hold it
there.
The window closes without jam protection.
Glass sunroof, electric
General information
The glass sunroof is ready for operation when
standby state is switched on.
Safety information
WARNING
Body parts can be jammed when operating the
glass sunroof. There is a risk of injury. Make
sure that the area of movement of the glass
sunroof is clear during opening and closing.
Overview
Tilting the glass sunroof
Push switch briefly upward.
▷ The closed glass sunroof tilts.
▷ The opened glass sunroof
closes until it is in the tilted
position. The sun protection
does not move.
Opening/closing the glass sunroof
and sun protection
▷ Press the switch in the desired
direction to the resistance
point and hold it there.
Seite 85
Opening and closing
CONTROLS
85
Online Edition for Part no. 01402989267 - II/18
To Next Page
Loading...
