BMW i7 - Page 223

In vehicles without distance control: turn on the
Cruise Control with the buttons on the steering
wheel.
1. If necessary, press the button.
2. If necessary, press the button re-
peatedly until the Cruise Control is selected.
Cruise control is active. The current speed is
maintained and stored as desired speed.
The indicator lights in the instrument cluster
illuminate and the mark on the speedometer is
set to the current speed.
The driving mode changes or Dynamic Sta-
bility Control activates when cruise control is
switched on.
Turning the speed control system
off/interrupting
The speed control system can be turned off or
canceled automatically or manually.
Additional information:
Speed control systems, refer to page 219.
Adjusting the speed
Store/maintain speed
Press the rocker button up or down
once while the system is stopped.
When the system is switched on, the current
speed is maintained and stored as the set
speed.
The stored speed is displayed on the speed-
ometer.
When the Speed Limit Assistant is not active,
the current speed can also be stored by press-
ing a button:
Press the button.
Changing the speed
Repeatedly press the rocker button up
or down until the desired speed is set.
If active, the displayed speed is stored
and the vehicle reaches the stored speed
when the road is clear.
The maximum speed that can be set depends
on the vehicle.
Press rocker button to resistance point and
hold: The vehicle accelerates or decelerates
without the accelerator pedal being pressed.
After the rocker button is released, the vehicle
maintains the final speed achieved. Pressing
the switch beyond the resistance point causes
the vehicle to accelerate more rapidly.
Continuing cruise control
With saved speed
Warning
The set speed can be incorrectly adjusted
or called up by mistake. There is a risk of
accident. Adjust the set speed to the traffic
conditions. Watch surrounding traffic closely
and actively intervene where appropriate.
An interrupted cruise control can be continued
by calling up the stored speed. The difference
between the current speed and the stored
speed should be as little as possible.
Press the button with the system inter-
rupted.
Cruise control is continued with the stored val-
ues.
In the following cases, the stored speed value
is deleted and cannot be called up again:
▷
When the system is switched off.
▷ When drive-ready state is switched off.
Seite 223
Driver assistance systems
CONTROLS
223
Online Edition for Part no. 01405A88D67 - VI/23