▷ Departure time is set.
▷ Departure time is activated.
Setting a time frame for charging
1. Apps menu
2. "Vehicle"
3. "Charging"
4. "Charging mode"
5. "Time slot"
6. Select the desired setting:
▷ "CO₂ emissions": Power sources with
low or no CO2 emissions will be prefer-
red, e.g., electricity generated from bio-
mass or nuclear power.
▷ "Renewable energy sources": Renewa-
ble energy sources will be preferred,
e.g., electricity generated from wind or
solar.
▷ "Charging costs": Cheaper electricity will
be preferred for charging, e.g., at certain
times of day.
Charge target
Principle
A target value in percent can be set for charg-
ing the high-voltage battery.
When a lower target value is set, the charging
time may be shortened.
General information
Charging with a set charging target is espe-
cially suitable for charging at DC charging sta-
tions.
A target value of 80 % is recommended for
optimal use of the function.
Target values below 20 % cannot be set.
Set charge target
1.
Apps menu
2. "Vehicle"
3. "Charging"
4. "Charging target"
5. Select the desired setting.
Permissible volume of DC charging
When the vehicle is charged at a DC charging
station, the noise emission during the charging
process can be limited, for instance to comply
with the local noise level restrictions. A limita-
tion of the noise emission can lead to longer
charging times.
1. Apps menu
2. "Vehicle"
3. "Charging"
4. "Fan loudness"
5. Select the desired setting.
Stopping the charging process
The charging process can be stopped at any
time by removing the charging cable and con-
tinued at a later time by connecting the charg-
ing cable. For example, so that other people
can use the electrical connection in the mean-
time, or in order to avoid excessive strain on
the electrical connection.
Additional information:
Detach, refer to page 320.
Continuing the charging process
If the charging process is interrupted, for in-
stance due to a temporary power failure, the
charging process will continue automatically
after the interruption.
When the vehicle is charged at a public charg-
ing station, the charging process may not con-
tinue automatically after an interruption.
Ending the charging process
1.
Remove the charging cable from the vehi-
cle.
Seite 325
Charging the vehicle
MOBILITY
325
Online Edition for Part no. 01405A88D67 - VI/23
To Next Page
Loading...
