BMW K 1600 GTL Exclusive User Manual

control units can be adapted for
the new wheel sizes.
TPC/RDC sticker
ATTENTION
Improper tire removal.
Damage to the TPC/RDC sen-
sors.
Inform a specialist service
facility or an authorized
BMW Motorrad retailer on the
fact that the wheel is equipped
with a TPC/RDC sensor.
On motorcycles equipped with
TPC/RDC, a corresponding
sticker is located on the wheel
rim at the position of the TPC/
RDC sensor. During a tire
change it must be ensured
that the TPC/RDC sensor
is not damaged. Inform the
BMW Motorrad retailer or the
authorized workshop of the TPC/
RDC sensor.
Removing front wheel
Make sure ground is level and
firm and place motorcycle on
its center stand.
Remove screws 1 on left and
right.
Pull out front wheel cover to-
ward front.
Unclip retaining clip 1 holding
the sensor cable to the brake
line.
Remove cable tie 2.
Mask off area of wheel rim that
could be scratched in process
of removing brake calipers.
8
119
z Maintenance

BMW K 1600 GTL Exclusive Specifications

General

Displacement	1649 cc
Rear Suspension	BMW Motorrad Paralever
Rear Brakes	Single 320 mm disc, 2-piston caliper
Tire Front	120/70 ZR 17
Tire Rear	190/55 ZR 17
Engine Type	Liquid-cooled, 4-stroke in-line six-cylinder
Power	160 hp at 7750 rpm
Torque	175 Nm at 5250 rpm
Transmission	6-speed
Fuel Capacity	26.5 liters
Seat Height	750 mm
Weight	364 kg (unladen weight, road ready, fully fueled)
Front Suspension	BMW Motorrad Duolever
Front Brakes	Dual 320 mm discs, 4-piston calipers
Length	2489 mm
Width	1000 mm
Wheelbase	1, 618 mm
Height	1, 465 mm