104n
BMW Universal Transmitter*
Programming
1 Channel keys
2 Indicator lamp
3 Receiver for programming
Read and comply with the safety
precautions on page 103.<
1 Ignition key position 2
2 For initial operation: press and hold
the two outer keys (1) until the indi-
cator lamp (2) flashes. Release the
keys. The three channel keys are
cleared.
390de640
3 Hold the original hand-held trans-
mitter toward the receiver (3) a
maximum of 2 in (5 cm) away.
4 Simultaneously press the transmitting
key of the original hand-held trans-
mitter (arrow 2) and the desired
channel key of the BMW Universal
Transmitter (arrow 1). Release both
keys as soon as the indicator lamp
flashes rapidly.
5 To program other original hand-held
transmitters, repeat steps 3 and 4.
The corresponding channel key is now
programmed with the signal of the
original hand-held transmitter.
380de712
Programming a hand-held
transmitter with change code
Read and comply with the safety
precautions on page 103.<
Consult the operating instructions for
the individual device when program-
ming the BMW Universal Transmitter.
Read and comply with the following
programming instructions for the use of
the BMW Universal Transmitter with a
change code system:
A second person simplifies
programming of the BMW
Universal Transmitter.<
To Next Page
Loading...
Need help?
General
