Fig. 95: Removing Main Bearing Caps
Courtesy of BMW OF NORTH AMERICA, INC.
Remove main bearing caps (1 to 7).
Lever out crankshaft.
If necessary, release incremental gear.
Replace screws.
Install screws and tighten down in two passes.
Tightening torque 11 21 1AZ. Refer to ENGINE - TIGHTENING TORQUES .
IMPORTANT: Check grinding stage of crankshaft. Refer to ENGINE - TECHNICAL DATA .
2006 BMW X5 30i
2004-2006 ENGINE Engine Mechanical - Repair Instructions - X3 & X5 (M54)
sábado, 2 de octubre de 2021 11:25:51 p. m. Page 100 © 2011 Mitchell Repair Information Company, LLC.
To Next Page
Loading...
