invariably log on all the remote
controls in the set.
Enable logon of the remote
controls as follows:
Switch on the ignition.
Press button 2 on the remote
control three times.
One acoustic signal sounds.
Within ten seconds, switch off
the ignition.
You can now proceed to log on
all the remote controls.
Step through the following pro-
cedure with each remote con-
trol in turn:
Press and hold down buttons 1
and 2 until LED 3 stops flash-
ing.
LED 3 flashes for approx. 10
seconds.
Release buttons 1 and 2.
LED 3 lights up.
Press button 1 or button 2.
One acoustic signal sounds,
LED 3 goes out.
To complete logon:
Switch off the ignition.
Three acoustic signals sound.
Logon is also ended in the fol-
lowing situations:
4 remote control units have
been logged on.
No button pressed within ap-
proximately 30 seconds of lo-
gon on the first remote control.
Synchronise the remote
controls
with central locking system
OE
with alarm system (DWA)
OE
without Keyless Ride
OE
If the central locking system
stops responding to the signals
from a remote control, the unit in
question has to be synchronised.
This can happen, for example, if
the buttons on the remote con-
trol were pressed too frequently
while the remote control was out
of range of the anti-theft alarm.
The procedure for synchron-
ising the remote controls is as
follows:
4
84
z
Operation
To Next Page
Loading...
Need help?
General
