IMPORTANT NOTE: the pattern is sent by using the SCPI command
AWGControl:DJStrobe only.
Note: The sequencer can jump immediately or when all the repetitions have been
executed as selected in the Jump Mode field (Device Settings ➔ General section).
Defines the target entry index for the “Pattern Jump” feature.
As soon as the sequencer receives the pattern event, it will jump to the entry
selected in this field.
• Next: the sequencer jumps to the next element in the sequence
• Previous: the sequencer jumps to the previous element in the sequence.
• First: the sequencer jumps to the first element in the sequence
• Last: the sequencer jumps to the last element in the sequence
• Item: the sequencer jumps to the selected entry index.
To Next Page
Loading...