1. Prepare Stroller
Set parking brake, rotate canopy
towards handlebar, place Restraint Belt
ends to the sides of stroller seat (see
stroller owner’s manual if necessary).
2. Align Infant Car Seat
Place Infant Car Seat “rear facing”
directly centered on top of ICSA, align
Groove Features on Infant Car Seat
with Front and Middle Tubes on ICSA.
3. Verify Infant Car Seat is Latched
Properly
Push Infant Car Seat straight down
onto ICSA until the adapters on each
side lock into the receivers on ICSA.
4. Verify Infant Car Seat is
Securely Attached
Pull up to ensure the Infant Car
Seat is secure.
5. Secure Restraint Belt
Proceed to section titled “Securing
Restraint Belt” (pg.14).
Failure to properly
secure Restraint Belt and
to properly install Infant
Car Seat on Infant Car
Seat Adapter may result
in accident, injury or
death.
CS1107 ICSA PEG PEREGO
PRIMO VIAGGIO SIP & SIP 30/30
To Next Page
Loading...
