BOB Sun Shield - User Manual

Congratulations on your purchase of the BOB Sun Shield.
It is designed to protect your childs delicate eyes and skin
from heat, glare, and ultraviolet (UVA/UVB) rays.
It also provides protection from wind and flying insects.
Proper installation and care will provide years of reliable
service.
Before attempting to use or attach your new Sun Shield,
read and understand these instructions completely to
insure proper assembly and operation. If you are unclear
on any point, contact your dealer or BOB before use.
Warnings
.
This product is designed exclusively for use with BOB
Sport Utility, Sport Utility DLux and Ironman strollers.
It is not intended for use with other strollers or products.
.
The Sun Shield is not designed to work with optional Infant
Car Seat Adapter and car seat.
.
Never leave child unattended.
.
The Sun Shield reduces the exposure to sun and heat but
does not eliminate it. Avoid exposing your child to prolonged
sun and heat.
.
It is possible for small insects to enter through the small
gaps between the shield and the stroller.
.
When not in use, keep out of reach of children.
.
When the Sun Shield is used, the rear canopy flap must
be in correct position as described below. This will insure
proper air flow and ventilation for your child.
INSTALLATION INSTRUCTIONS:
1. Set stroller Parking Brake (refer to Parking Brake section
of stroller Owners Manual). Place sun canopy into position
to receive the Sun Shield as shown in Fig.1.
2. Pull canopy drawstring in order to gather extra material
under canopy. Cinch cord lock against canopy to retract and
hold material, as shown in Fig. 2.
Very Important: When the Sun Shield is used, the rear
canopy flap must be in correct position as described
below. This will insure proper air flow and ventilation
for your child.
3. Locate rear canopy flap and fold forward. Attach canopy
flap Velcro on flap to respective Velcro mate on top outboard
side of each canopy as shown in Fig. 3). Warning tag on
rear canopy flap also describes and illustrates this critical
step.
4. Inspect opening at back of stroller to make sure the air
passage between top of seat back and canopy is unobstructed
(see Fig. 4). We recommend reclining each seat back slightly
to optimize airflow (refer to Reclining Seat section of stroller
Owners Manual).
5. Place Sun Shield on the stroller so the rear flap drapes
over back (between the handlebar) and the seam above the
window is aligned with the forward Sun Canopy support (see
Fig. 5).
6. Stretch the elastic cord on each side under each respective
black shock knob as shown in Fig. 6. There is an opening
mid way up each side (with silver reflective fabric on each
P1
(800) 893-2447 www.bobgear.com email- info@bobgear.com Ph: (208) 375-5171
Fax: (208) 375-5172, BOB Trailers, Inc. 5475 Gage St. Boise, ID 83706
spor
spor
t utility s
t utility s
tr
tr
oller sun Shield ins
oller sun Shield ins
tr
tr
uctions
uctions
Fig. 1 Canopy Supports
in positon.
Forward
Canopy
Support
Aft Canopy Support
Fully Rotated Back
Rear
Canopy
Flap
Fig. 2 Canopy Drawstring
Adjustment
Cinch Cord
Lock tight
against Canopy
Fig. 3 Canopy Flap in Position
Air Passage
Fig. 4 Rear Vent Unobstructed
Fig. 5 Shield placed on Canopy
Align Sun
Shield
Seam with
Forward
Canopy
Supports
Elastic
Cord
End
Loop
Fig. 6 Elastic cord attachment
Silver
Reflective
Fabric
Elastic Loop
Around Black
Shock Knob
Elastic Cord
Under Black
Shock Knob
Fig. 7 Front attachment:
Insert Stay ends into holes.
plastic Plugs with holes
Ends of metal Stay
OMA25

Summary

General Safety Warnings

Product Compatibility and Usage

Ensures correct stroller model and warns against car seat use.

Child Safety and Product Limitations

Never leave child unattended; limits sun/heat exposure.

Environmental Factors and Storage

Notes insect entry possibility and storage safety.

Sun Shield Installation

Prepare Stroller and Canopy

Set parking brake and adjust canopy drawstring.

Attach Rear Canopy Flap

Fold forward rear canopy flap and attach Velcro.

Inspect Air Passage

Ensure air passage between seat back and canopy is clear.

Position and Align Sun Shield

Align shield seam with forward canopy supports.

Secure Elastic Cords

Stretch elastic cords under black shock knobs.

Attach Front Stay

Insert metal wire stay ends into front plug holes.

Route Side Elastic Edges

Stretch elastic edges under respective frame tubes.

Final Check and Child Placement

Center rear flap, inspect air passage, and temporarily lift shield.

Care and Maintenance

Cleaning Instructions

Hand wash cold and hang dry; avoid dry cleaning, ironing, or dryer.

Product Warranty Information

Warranty Coverage and Limitations

One-year warranty for defects; excludes normal wear, abuse, etc.

Warranty Claim Procedure

Requires proof of purchase and claims via authorized dealer.

BOB Sun Shield Specifications

General

Brand	BOB
Model	Sun Shield
Category	Stroller
Language	English