Adjusting the Gears
Gingersnap 20” and Gingersnap 24”
The gears will probably not need adjustment
straight away, however after a few weeks of riding
the gear cable will loosen a little and they may
need adjustment then. This is completely normal
on all bikes using derailleur gears and is not a fault.
Adjustment is simple.
Before you begin the adjustment, click through the
gears so that the chain is on the smallest cog.
• Turn the barrel adjuster ¼ turn to the left (anti-
clockwise if viewed from the rear of the bike)
• Click through the gears again to check
everything is smooth. Turn ¼ again if necessary.
To Next Page
Loading...