Bobcat 741 - Page 109

REDUCTION GEARCASE (Cont'd)
Installation (Cont'd)
Tighten the five bolts to 220-245 ft. -Ibs . (300-330 Nm)
torque.
Install the hydrostatic motor [B].
Install the bolts and tighten to 65-70 ft.-Ibs. (88-95 Nm)
torque.
Connect the hoses to the motor and tighten.
Install the motor cover.
Install the transmission covers and the brake assembly.
(See Page 4-12 .)
CHAINCASE FLUID
Replacing Chaincase Fluid
Remove the front transmission cover. (See Page 4-2 .)
Use a pump to remove all the fluid from the chaincase [C].
MEL
10628 - Hydraulic Transfer Pump
A
B
c
Use clean rags to remove any fluid that the pump did not
remove and to
clean the chaincase [0]. 0
Use only recommended replacement fluid. Bobcat Fluid
(PIN
6563328) or 1 OW-30 or 1 OW-40 Class SE Motor Oil
to fill the chaincase with 9 gals. (34 L) of fluid.
Install the front transmission cover. (See Page 4-2.)
-4-20-
741,742,743, 7430S Bobcat Loader
Service Manual