ENGINE FRONT COVER
Removal
Remove the fuel injection pump. (See Page
7A-3
.)
Remove the cooling blower, generator and pulley from the
governor shaft.
Remove the cover bolts.
Remove the front cover. Be careful not to lose the dowel
pins.
Disassembly And Assembly
Put new sealing washers under the two plugs [A].
Remove the old seal from the governor shaft [B].
Install a new seal [C].
Check the excess fuel button for damage
or
wear.
Replace the
O-ring
and put grease
in
the center groove
for the
O-ring
[0].
-7A-27-
741, 742, 743,
7430S
Bobcat Loader
Service Manual
To Next Page