PARKING BRAKE (Cont'd)
Block and Pucks
Remove the brake lever [A).
Installation: Tighten the bolt to
65-70
ft
.-
Ibs.
(88-95
Nm) torque.
A
Remove the bolts which fasten the brake block to the
r"l:;l-------fis=======:::l
transmission cover [B]. B
Installation: Put thread sealant on the bolts and tighten
to
65-70
ft.-Ibs. (88-95 Nm) torque.
Remove the pucks from the
block [C].
Check the pucks for wear or damage. The pucks can be
turned
180
0
and used again.
Check for a good fit between the pucks and the block
bore. They must
slide
in
and out freely.
Install
the new O-ring on the cam pin [0].
-4-3-
' .
D
'\
8-05208
741,742,
743,
7430S
Bobcat Loader
Service Manual
To Next Page