Bobcat 743 - Page 43

,
\
I
j
j
I
I
(
o
Add grease as needed to the steering
control shaft (Fig. 76, Item 1).
OPERATOR GUARD
The Bobcat loader has a operator guard
(ROPS and FOPS) as standard
equipment. The ROPS and FOPS
protects the operator from roll over and
falling objects.
D
--,
/ /
/-401'1-
~~~~
Fig. 76 Steering Control lubrication
Never change the operator guard by
welding, grinding, drilling holes or
adding attachments that are not
approved. This can weaken the
operator guard and cause personal
injury or death.
D-1432R
Check with your authorized dealer if the operator guard has been damaged.
Make sure the operator guard fastening bolts and nuts are tight (Fig. 77).
BOB-TACH
Check for free movement of wedges
and Bob-Tach levers.
When the Bob-Tach levers (Fig. 78,
Item 1) are pushed down into the
locked position, the wedges must
extend far enough to engage into the
holes of the attachment (Fig. 79).
Replace wedges that are bent or
broken.
Fig.
78 Bob-Tach
-35-
C-2204R
C-2599
Fig. 77 Tightening Operator Guard Bolts
Fig. 79 locking Wedges
743 Loader
Operator's Manual