58 S130 Operation & Maintenance Manual
DRIVE RESPONSE
Drive Response is available on SJC equipped machines.
NOTE: An upgrade to the loader software can be
required if this feature does not function as
described in this manual. See your Bobcat
dealer to update your machine software
version if necessary.
Description
Drive Response changes how responsive (more or less)
the loader drive and steering systems are when the
operator moves the joystick(s).
Drive Response can be changed by the operator for
different drive response preferences and various job
conditions and attachment use.
NOTE: Changes to drive response do not affect
braking or stopping the loader.
There are three drive response settings:
• [DR-1] provides a smooth responsive reaction to
joystick movement. (Drive only)
• [DR-2] is the default setting and provides a normal
responsive reaction to joystick movement. (Drive
only)
• [DR-3] provides a quick responsive reaction to
joystick movement. (Drive only)
Operation
NOTE: Changes CANNOT
be performed until the seat
bar is lowered, the engine is started and the
PRESS TO OPERATE LOADER button is
pressed to activate the BICS.
Perform pre-starting and starting procedures:
1. Fasten seat belt.
2. Lower seat bar.
3. Place joysticks in neutral position.
4. Start the engine.
5. Press the PRESS TO OPERATE LOADER button.
6. Current drive response setting will be displayed briefly
in the data display.
NOTE: Raising the seat bar or changing control
mode (ISO / H) will cause the machine to
disengage from drive response. The last
displayed setting will remain in effect until the
STOP button is pressed or the key is turned
OFF.
To Next Page
Loading...