64 S130 Operation & Maintenance Manual
HYDRAULIC CONTROLS (CONT’D)
Selectable Joystick Controls (SJC) In ‘H’ Control
Pattern
Figure 57
Lift Arm Operation - (Left Hand Joystick)
Move the joystick outward (Item 1) [Figure 57] to
raise the lift arms.
Move the joystick inward (Item 2) [Figure 57] to lower
the lift arms.
Lift Arm Float Position - (Left and Right Hand Joysticks)
Press and hold the Float button (Item 3) while the
joysticks are in neutral. Move the left joystick to lift
arm down position (Item 2) [Figure 57], then release
the button.
Press Float button (Item 3) [Figure 57] again or move
the left joystick to lift arm up position to disengage.
Use the float position of the lift arms to level loose
material while driving backward.
Figure 58
Tilt Operation - (Right Hand Joystick)
Move the joystick inward (Item 1) [Figure 58] to tilt the
bucket backward.
Move the joystick outward (Item 2) [Figure 58] to tilt
the bucket forward.
Hydraulic Bucket Positioning
The function of hydraulic bucket positioning is to keep the
bucket in the same approximate position it is in before
you begin raising the lift arms.
Figure 59
Press the top of the BUCKET POSITIONING switch (Item
1) [Figure 59] to engage the bucket positioning function.
The amber light in the switch will turn on. Press the
bottom of the switch to disengage. The amber light will
turn off.
Bucket positioning functions only during upward lift cycle.
To Next Page
Loading...