S250 Bobcat Loader
OI-24 Operation & Maintenance Manual
DAILY INSPECTION
Maintenance work must be done at regular intervals.
Failure to do so will result in excessive wear and early
failures. The Service Schedule (above) is a guide for
correct maintenance of the Bobcat loader. It is located
inside the rear door of the loader.
Daily Inspection and Maintenance
• Engine Oil Level
• Hydraulic/Hydrostatic Fluid Level
• Engine Air Filter, Check System for Damage or Leaks
• Engine Coolant System, Check System for Damage
or Leaks
• Operator Cab and Cab Mounting Hardware
• Seat Belt
• Seat Bar and Control Interlocks
• Grease Pivot Pins (Lift Arms, Bob-Tach, Cylinders,
Bob-Tach Wedges)
• Tires, Check for Wear, Damage, Correct Air Pressure
• Fuel Filter, Remove Trapped Water
• Loose or Broken Parts, Repair or Replace as
Necessary
• Lift Arm Support Device. Replace if Damaged
• Bobcat Interlock Control System (BICS)
WARNING
Operator must have instructions before running the
machine. Untrained operators can cause injury or
death.
W-2001-0596
NOTE: Fluids such as engine oil, hydraulic fluid,
coolant, etc. must be disposed of in an
environmentally safe manner. Some
regulations require that certain spills and
leaks on the ground must be cleaned in a
specific manner. See local, state and federal
regulations for correct disposal.
6734534
To Next Page
Loading...