Bobcat s250 - Page 46

S250 Bobcat Loader
OI-26 Operation & Maintenance Manual
PRE-STARTING PROCEDURES (CONT’D)
Before Starting The Engine (Cont’d)
Figure OI-45
Squeeze both seat belt adjusters to release and lengthen
each half of the seat belt [Figure OI-45].
Fasten the seat belt.
Pull the ends of the belt through the belt adjusters so that
the seat belt is snug and the buckle is centered between
your hips [Figure OI-45].
Figure OI-46
3-Point Restraint - (Option & Loaders with 2-Speed)
Connect the shoulder belt to the lap belt (Item 1)
[Figure OI-46]. Pull the lap belt across to the left side of
the seat (Item 2) [Figure OI-46] and fasten.
The shoulder belt must be positioned over your right
shoulder and lap belt over your lower hips
[Figure OI-46] .
IMPORTANT
Check the seat belt and shoulder belt retractors for
correct operation.
Keep retractors clean and replace as necessary.
I-2199-0400
Always fasten the shoulder belt for additional restraint
when operating in high range speed.
P-16038
P-16041
N-21773
1
N-21773
2