112 S650 Operation & Maintenance Manual
OPERATING PROCEDURE (CONT’D)
Filling And Emptying The Bucket (Foot Pedals)
Filling
Figure 150
Figure 151
Lower the lift arms all the way (Item 1) [Figure 150].
Tilt the bucket forward (Item 2) [Figure 150] until the
cutting edge of the bucket is on the ground.
Drive slowly forward into the material. Tilt the bucket
backward (Item 1) [Figure 151] all the way when the
bucket is full.
Drive backward away from the material.
WARNING
Load, unload and turn on flat level ground. Do not
exceed Rated Operating Capacity (ROC) shown on
sign (decal) in cab. Failure to obey warnings can
cause the machine to tip or roll over and cause injury
or death.
W-2056-0903
Emptying
Figure 152
Keep the bucket low when moving to the area where you
want to empty the bucket.
Raise the lift arms (Item 1) [Figure 152]. Level the bucket
(Item 2) [Figure 152] while raising the lift arms to help
prevent material from falling off the back of the bucket.
Drive forward slowly until the bucket is over the top of the
truck box or bin.
Empty the bucket (Item 2) [Figure 152]. If all the material
is near the side of the truck or bin, use the bucket tilt to
move it to the other side.
WARNING
Never dump over an obstruction, such as a post, that
can enter the operator cab. The machine could tip
forward and cause injury or death.
W-2057-0694
NA1689
B-15973
1
2
NA1690
B-15973
1
NA1697
B-15973
1
2
To Next Page
Loading...