161 S650 Operation & Maintenance Manual
ELECTRICAL SYSTEM (CONT’D)
Battery Maintenance
Figure 236
The battery cables must be clean and tight [Figure 236].
Check electrolyte level in the battery. Add distilled water
as needed. Remove acid or corrosion from battery and
cables with sodium bicarbonate (baking soda) and water
solution.
Put Bobcat Battery Saver or grease on the battery
terminals and cable ends to prevent corrosion.
WARNING
AVOID INJURY OR DEATH
Batteries contain acid which burns eyes and skin on
contact. Wear goggles, protective clothing and
rubber gloves to keep acid off body.
In case of acid contact, wash immediately with water.
In case of eye contact get prompt medical attention
and wash eye with clean, cool water for at least 15
minutes.
If electrolyte is taken internally drink large quantities
of water or milk! DO NOT induce vomiting. Get
prompt medical attention.
W-2065-0807
P-09589
P-09590
To Next Page
Loading...