Bobcat S650 - Page 45

43 S650 Operation & Maintenance Manual
INSTRUMENT PANEL IDENTIFICATION (CONT’D)
Left Panel (Cont’d)
* See SYSTEM SETUP & ANALYSIS for Service Code description. (See DIAGNOSTIC SERVICE CODES on Page 187.)
REF.
NO.
DESCRIPTION FUNCTION / OPERATION
1 ENGINE TEMPERATURE GAUGE Shows the engine coolant temperature.
2 LEFT TURN SIGNAL (Option) Indicates left turn signals are ON.
3 GENERAL WARNING Malfunction with one or more machine functions. (See Service Codes*)
4 TWO-SPEED (Option) High range selected.
5 ENGINE MALFUNCTION Engine malfunction or failure. (See Service Codes*)
6 ENGINE COOLANT TEMPERATURE Engine coolant temperature high or sensor error.
7 DISPLAY SCREEN Displays information. (See Display Screen in this manual.)
8 SEAT BELT Instructs operator to fasten seat belt. Remains lit for 45 seconds.
9 SEAT BAR The light comes on when the seat bar is UP.
10 LIFT & TILT VALVE The light comes on when the lift and tilt functions cannot be operated.
11 PARKING BRAKE The light comes on when the loader cannot be driven.
12 RIGHT TURN SIGNAL (Option) Indicates right turn signals are ON.
13 SHOULDER BELT (Option) Instructs operator to fasten shoulder belt when operating in high range.
Remains lit while in high range.
14 HYDRAULIC SYSTEM MALFUNCTION Hydraulic system malfunction or failure. (See Service Codes*)
15 FUEL Fuel level low or sensor error.
16 FUEL GAUGE Shows the amount of fuel in the tank.
17 LIGHTS - Without Road Option
- With Road Option
- All Loaders
Press once for REAR taillights. (Right green LED will light.) Press a
second time to turn FRONT and REAR work lights ON. REAR taillights
will turn OFF. (Left green LED will light.) Press a third time to turn all
lights off. (Left and right green LEDs will be off.)
Press once for FRONT boom light, license plate light and REAR
taillights. (Right green LED will light.) Press a second time to turn
FRONT and REAR work lights ON. FRONT boom light, license plate
light and REAR taillights will turn OFF. (Left green LED will light.) Press
a third time to turn all lights off. (Left and right green LEDs will be off.)
Press and hold five seconds to show software version in display
screen.
18 HIGH-FLOW (Option) Press once to engage the HIGH-FLOW auxiliary hydraulics. (Left green
LED will light.) Press a second time to disengage.
19 AUXILIARY HYDRAULICS Press once to activate the auxiliary hydraulic system. (Left green LED
will light.) Press a second time to deactivate the system.