Bobcat S650 - Page 78

76 S650 Operation & Maintenance Manual
STEERING DRIFT COMPENSATION (CONT’D)
Operation (Cont’d)
Figure 68
Press and hold the PRESS TO OPERATE LOADER
button (Item 1) for three seconds to access the drive
response adjustment menu. Press the PRESS TO
OPERATE LOADER button (Item 1) again to adjust the
loaders steering drift compensation setting. The current
steering drift compensation setting will appear in the data
display (Item 2) [Figure 68].
Press the upper left button (Item 6) on the left joystick to
adjust the machine left. [S-L01] (Item 3) through a
maximum of [S-L10] will appear in the data display (Item
2) [Figure 68]. The number will increase by one each
time you press the button. The higher the number, the
greater the amount of steering drift compensation to the
left. Adjustments to steering drift compensation will be
effective immediately.
Press the upper right button (Item 7) on the left joystick to
adjust back toward centre. The display will decrease
down to neutral displayed as [S----] (Item 4). Another
press of the upper right button will cause [S-R01] (Item 5)
to appear in the data display (Item 2) [Figure 68]. The
number will increase by one each time you press the
button up to a maximum of [S-R10]. The higher the
number, the greater the amount of steering drift
compensation to the right. Adjustments to steering drift
compensation will be effective immediately.
Figure 69
Saving The Steering Drift Compensation Setting:
The current steering drift compensation setting can be
saved by pressing and holding the PRESS TO OPERATE
LOADER button (Item 1) for three seconds. [SET] (Item
3) will appear in the data display (Item 2) [Figure 69] and
the machine will exit from the steering drift compensation
adjustment menu.
OR
Press the PRESS TO OPERATE LOADER button to exit
from the steering drift compensation adjustment menu
without saving the current setting. [DONE] (Item 4) will
appear in the data display (Item 2) [Figure 69] and the
upper left and upper right buttons on the left joystick will
no longer make changes to steering drift compensation.
NOTE: The last displayed steering drift
compensation setting will remain in effect
until the machine is turned OFF. The machine
will revert back to the last saved setting the
next time it is started.
P-24820C
6
7
P-24802C
Left Joystick Right Joystick
1
2
NA1011
P-76461L
P-76461N
P-76461M
4
5
3
1
2
NA1011
P-76461K
P-76461O
4
3