75 S650 Operation & Maintenance Manual
STEERING DRIFT COMPENSATION
Steering Drift Compensation is available on SJC
equipped machines.
Description
Steering Drift Compensation can be used to reduce
steering drift to maintain a desired travel path in both
forward and reverse directions.
Examples of applications where this feature can be used:
• To compensate for normal variations such as tyre
inflation pressure, track tension, tyre wear and track
wear.
• Using side shift attachments such as trenchers,
planers and silt fence installers.
• Driving on uneven terrain such as crowned road
surfaces.
Figure 67
Steering drift compensation contains a total of 21
settings. Steering drift compensation can be set to any
point from neutral to [S-L10] left and from neutral to [S-
R10] right. [S----] is displayed when set for neutral
[Figure 67].
Operation
NOTE: Changes CANNOT be performed until the seat
bar is lowered, the engine is started and the
PRESS TO OPERATE LOADER button is
pressed to activate the BICS™.
Perform pre-starting and starting procedures:
1. Fasten seat belt.
2. Lower seat bar.
3. Place joysticks in neutral position.
4. Start the engine.
5. Press the PRESS TO OPERATE LOADER button.
6. Current drive response setting will be displayed briefly
in the data display.
NOTE: Raising the seat bar or changing control
mode (ISO / H) will cause the machine to
disengage from steering drift compensation.
The last displayed setting will remain in effect
until the machine is turned OFF.
B-23580C
STEERING DRIFT COMPENSATION
To Next Page
Loading...