87 S650 Operation & Maintenance Manual
DAILY INSPECTION (CONT’D)
Daily Inspection And Maintenance (Cont’d)
The following list of items must be checked daily:
• Engine Oil Level
• Hydraulic Fluid Level
• Engine Air Filter - Check System for Damage or
Leaks
• Engine Cooling System - Check System for Damage
or Leaks, Check Coolant Level, Clean Oil Cooler,
Radiator and Rear Grille
• Operator Cab and Cab Mounting Hardware
•Seat Belt
• Seat Bar and Control Interlocks
• Bobcat Interlock Control System (BICS™)
• Front Horn - Check for Proper Function
• Grease Pivot Pins (Lift Arms, Lift Links, Bob-Tach,
Cylinders, Bob-Tach Wedges)
• Tyres - Check for Wear, Damage, Correct Air
Pressure
• Fuel Filter - Remove Trapped Water
• Loose or Broken Parts - Repair or Replace as
Necessary
• Safety Treads and Safety Signs (Decals) - Replace as
necessary
• Lift Arm Support Device - Replace if Damaged
IMPORTANT
This machine is factory equipped with a spark
arrester exhaust system.
The spark arrester muffler, if equipped, must be
cleaned to keep it in working condition. The spark
arrester muffler must be serviced by dumping the
spark chamber every 100 hours of operation.
On some models, the turbocharger functions as the
spark arrester and must operate correctly for proper
spark arrester function.
If this machine is operated on flammable forest,
brush, or grass covered land, a spark arrester
attached to the exhaust system may be required and
must be maintained in working order. Refer to local
laws and regulations for spark arrester requirements.
I-2284-EN-0909
IMPORTANT
PRESSURE WASHING DECALS
• Never direct the stream at a low angle toward the
decal that could damage the decal causing it to
peel from the surface.
• Direct the stream at a 90 degree angle and at
least 300 mm (12 in) from the decal. Wash from
the centre of the decal toward the edges.
I-2226-EN-0910
To Next Page
Loading...