6. If youwant to activatetheauto-clean functionto cleantheappliance, follow the
operation as below. Firstly, put theappliance ontothe charger to performcharging, and
then press the Auto clean button to perform auto cleaning for 30 seconds.And the
light ring
will keep illuminating during the auto-clean process.
PRODUCT SPECIFICATION
Product name
：
Model：
Specificationof battery pack:
DC36V/ Lithium
Power
：
256W
VC1901A
2600mAhBattery Capacity
BOBOT DEEP830
NOTE: The auto-clean function can be only activated when the appliance is
being charged.
3. Rinse the dirty water tank with clean water(see Fig.18).
4.Activate the uto clean"function by following the operation as above to clean
theroller brush, then remove the roller brush by following the reverse operation
mentioned inthe section of fNSTALLATION FOR THE ROLLER BRUSH”.And then
store theroller brush at the corresponding position of the charger(see Fig.19).
The appliance shouldbe stored at a place with good draft and without exposure
to the direct sunlight.
CLEANING THE DIRTY WATER TANK AND THE ROLLER BRUSH1. Grasp the fastener of
dirty water tank and then press the button of the dirty water tank downwards to
remove the dirty water tank (see Fig.16).
2.Remove the lid of dirty water tank and then empty the drty water tank (see Fig.17).
The roller brush should be replaced every 6 months, which may vary depending on
theoperating environment and the running time.
Fig.16
Fig.18
Fig.17
Fig.19
OPERATION PRODUCT SPECIFICATION
REPLACEMENT OF THE ROLLER BRUSH
To Next Page
Loading...