Filters
Three lters are located inside the dustbin’s ceiling in order to capture ne particles
and allergens and prevent their escape from the dustbin.
- To remove the lters, rst eject the dustbin, then hold the middle of the lter’s
frame and pull it towards you.
- You will see three layers of lter:
+ Mesh lter for larger particles.
+ Pre-lter or electrostatic lter for ne particles.
+ HEPA lter for sub-micron particles.
- Brush dust o the lters. It is recommended that you change the pre-lter
and the HEPA lter every 4-6 months depending on the frequency/intensity of
cleaning.
- There is also a small lter at the back of the dustbin. Open the small vent on
the back of the dustbin and wash the sponge lter with cold water every once
in a while.
To Next Page
Loading...
