What to do if the "POWER" lamp does not light on my BOC Edwards Water Pump?
If the "POWER" lamp on your BOC Edwards Water Pump doesn't light up when you turn it on, check the following: * Ensure the power cable is correctly connected. * Verify that the power voltage is within the rated voltage ±10%. * Confirm whether a power failure has occurred.
What to do if there is another abnormality or error with my BOC Edwards Water Pump?
If you encounter another abnormality or error with your BOC Edwards Water Pump, take the following steps: 1. After confirming the "BRAKE" lamp is off and the pump stops, identify and eliminate the cause of the abnormality. 2. Perform the RESET operation to turn off the "FAILURE" lamp. 3. Perform the START operation to check if the pump operates correctly. 4. When disconnecting cables for troubleshooting, ensure the pump stops, turn OFF the primary power, and then disconnect the cables. 5. If the RESET operation does not turn off the "FAILURE" lamp, confirm that the pump stops, turn OFF the primary power, and then turn it ON again.
Why doesn't the "ACCEL." lamp light on my BOC Edwards Seiko Seiki STPH803C Water Pump?
If the "ACCEL." lamp on your BOC Edwards Water Pump does not light, check these items: * Ensure the "MANUAL/ REMOTE" changeover switch is in the correct position. * Verify that the ROTATION INHIBIT signal input pins (REMOTE X7 (1)-(5)) are correctly configured. If not in use, short the circuits between (1)-(5), or set "Inhibit Command" to "DISABLE." The pump will not rotate after starting if these pins are open.
Step-by-step instructions for installing the STP pump.
Guidelines and requirements before installing the STP control unit.
Details and procedures for connecting various cables.
Procedures for operating the STP pump manually.
Methods for starting and stopping the pump remotely.
Procedure for aligning the rotor levitation position.
How the pump reacts to power interruptions and recovery.
Steps to take immediately after an error occurs.
Guidance on interpreting and responding to LCD error messages.
Procedures for routine maintenance and inspection of the unit.
Detailed technical specifications for the STP pump models.
Detailed technical specifications for the STP control unit.
General| Brand | BOC Edwards |
|---|---|
| Model | Seiko Seiki STPH803C |
| Category | Water Pump |
| Language | English |
To Next Page
