Equipment's working environment could not be too severe. If temperature is higher than
30
℃，
lower than 18
℃，
and if there is too much dust, with severe air pollution, then the
machine could be badly damaged, failure rate goes up steadily. Various electric parts are
easily damaged under wet environment.
6.2 Water tank's change and clean (suggest to change water and clean water
tank per week)
Attention:
before machine starts to work, be sure that laser tube is full of water and without bubble.
Recycling water's quality and temperature could affect laser tube's lifespan directly. We
suggest to use pure water, and control the water under 35
℃
. If it's higher than 35, then
need to change recycling water, or add ice to water (we suggest customers choose water
chiller, or use two water tanks)
Clean water tank: firstly, switch off electric power, take off the water-inlet water tube to
let water inside laser tube go to water tank. Open water tank, take out water pump, clean
dirt on it. After cleaning water tank, changing new recycling water, put back the water
pump. Connecting water tube on pump to water-inlet gate, and other joints. Connect
electric power to water pump separately for 2-3 minutes(make laser tube be full of
recycling water).
6.3 Exhaust fan’s clean
After long term's using of exhaust fan, it would accumulate much solid dust, which could
make exhaust fan produce big noise and it is also not good for eliminating wasted air and
smell. When it occurs that exhaust fan is not good enough to suck and eliminate air, firstly
close the power, take off air-in and out tubes, remove dust inside, bottom up the exhaust
fan, roll fan blades inside until it's totally cleaned. Finally, set up the exhaust fan.
6.4 Reflectors' and lens' clean
(suggest to clean before working everyday, equipment should be under power off
situation)
There are 3 reflectors and 1 lens on Laser equipment(the first reflector is set on emission
exit of laser tube, mean on the laser equipment's upper-left side, the second reflector is on
the left side of transom, the third one is on the top side of laser head, lens is inside in lens
cone), laser beam is transmitted through these reflectors and lens. It's easily for mirrors to
smear dust and other dirt, which could result in laser's loss or mirrors' damage. The first
and second reflector needn't have to be taken off when do cleaning. Take lens wiping
paper with leaner to wipe reflectors from center to edge. The third one and lens need to
take off from lens frame and clean them with same way, and put back after finishing.
Attention:
①
wipe the reflectors and lens softly, do not damage their surface coating
film;
②
handle gently during wiping to avoid falling down;
③
the convexity side must be
To Next Page
